Non-Apple upgrades and peripherals (such as unsupported USB devices, replacement drives, and third-party memory) may cause problems when installing or booting into Mac OS X.īe sure to read and follow Apple’s “Read Before You Install” instructions to increase the likelihood of getting OS X installed and running on the first try. If the hard drive is set to slave, you will not be able to boot from it. If the CD-ROM is set to slave, you will not be able to install OS X. This applies to hard drives and CD-ROM drives. You can only boot OS X from a “master” drive. Mac OS X must be completely within the first 8 GB of space on your hard drive or you will not be able to run OS X. If you are creating the partition within OS X, it must be smaller than 7.45 as reported by Disk Utility (because sometimes a GB is billion bytes and sometimes it’s 1,073,741,824 bytes) we suggest simply setting it at 7 GB to avoid having to redo the whole installation if the partition ends up bigger than specified (it happens). If you have an IDE hard drive over 8 GB in size, you must partition it or you will not be able to install Mac OS X. These Macs can work successfully with larger drives for some time, but once a System file goes outside of the first 8 GB of space, you’ll have nothing but problems. Failure to do this could eventually result in an unbootable computer, as all System files must be within the first 8 GB of drive space. If you have a hard drive larger than 8 GB, you should partition is so that the first partition is under 8 GB in size (for simplicity, we suggest 7 GB). A lot of users, especially educators, missed having an integrated Power Mac with PCI slots. Unfortunately, this machine was discontinued to make room for the iMac. A 4 GB EIDE hard drive, 24x CD-ROM player, and 10Base-T ethernet are standard. The motherboard is on a slide-out tray for easier upgrade and service. The All-in-One was specifically designed for the education market, where less wires and parts to remove are a big plus. Key features include the G3 processor and a 15″ multiscan display (13.8″ viewable). You can find XPostFacto site’s comprehesive documentation at: The procedure in a nutshell is.The G3 All-in-One succeeded the Power Mac 5000 series for the education market. You’re dealing with an unsupported hack here. Before you think of giving XPostFacto a whirl, be sure to consult the compatibility chart at: Also, make sure your machine has been recently backed up. XPostFacto is a little hack that brings Mac OS X, OS X Server, and Darwin to older, unsupported, and forgotten Mac models - those draped in the unfashionable beige of times past. Then I stumbled across a little something called XPostFacto, which is open source and free. Mac OS 9 ran rather snappily and the machine served quite nicely as a USB print server. I recently gave an old 7500 a G3 upgrade card from Sonnet, a quad-port FireWire card, and a dual-port USB card (only $37, combined). Some of those old Macs will actually run Mac OS X 10.2 (Jaguar) - with a little help from an unassuming-looking control panel. Wait, don’t throw out that old Power Mac or Umax clone it may just be up for a little Mac OS X sprucing. OS X for This Old Mac Give your legacy Mac hardware a nudge into OS X with the XPostFacto hack.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |